Skoda Fabia

Since 2000 of release

Repair and car operation

11.8.8. Replacement of cables of a drive of a heater

THE GENERAL DATA

Detachment of a cable of a drive from the control panel a heater

1 – a cable; 2 – a latch; 3 – the control panel a heater

Detachment of a cable of a drive from a heater

1 – the adjusting device of a heater; 2 – a cable; 3 – a latch

Fixing of a cable of a drive of a heater in the holder

1 – a cable; 2 – the holder; 3 – a heater

The length of a cable 6 (fig. Removal of the control panel by a heater see) drive airdistributing заслонок in a cover of dark blue colour makes 250 mm, length of a cable 4 drives заслонки a heater radiator in a cover of violet colour – 256 mm.

PERFORMANCE ORDER

1. Remove a casing of the central console of the panel of devices, having pushed thus the control panel a heater inside (subsection 11.6 see). 2. Having pressed a uvula of a latch 2 (fig. the Detachment of a cable of a drive from the control panel a heater see), disconnect one end of a cable of 1 drive airdistributing заслонок from the panel of 3 managements of a heater. 3. Having pressed by means of a screw-driver a latch 3 (fig. the Detachment of a cable of a drive from a heater see), disconnect other end of a cable 2 from a heater. 4. Take out a cable 1 (fig. Fixing of a cable of a drive of a heater in the holder see) of the holder 2 on a heater. 5. Similarly remove a drive cable заслонки a heater radiator. 6. Connect and fix a cable of a drive airdistributing заслонок on the adjusting device on a heater. 7. By means of a cable turn заслонку обдува a windscreen so that it was completely open (see more low). 8. Establish the handle on the control panel a heater in position having blown in a windscreen. 9. In this position connect a cable to the control panel a heater and fix it. 10. Fix in the holder on a heater a cable of a drive airdistributing заслонок. The prevention At the established panel of devices заслонка обдува a windscreen it is not visible. In this case connect cables to the control panel a heater and include the fan for the maximum speed. Establish the handle on the control panel a heater in position having blown in a windscreen. Be convinced that from a lattice обдува a windscreen air arrives, and from snuffled обдува feet – is not present. Otherwise disconnect a cable of a drive airdistributing заслонок from the control panel, turn the handle of management of air giving on 360 , again connect a cable and once again check up correctness of work of a heater. 11. Connect and fix a drive cable заслонки a heater radiator on the lever a heater. 12. Turn a cable clockwise against the stop. 13. Establish the handle on the control panel a heater in position heating it is switched off. 14. In this position connect a cable to the control panel a heater and fix it. 15. Turning the handle of temperature of air on the control panel a heater, check up heater work.