Skoda Fabia

Since 2000 of release

Repair and car operation


Shkoda Fabija
+ 1.1. The car description
+ 2. The engine
+ 3. Greasing system
+ 4. The power supply system
+ 5. Cooling system
+ 6. System of release of the fulfilled gases
+ 7. Transmission and a running gear
+ 8. A steering
+ 9. Brake system
+ 10. An electric equipment
- 11. A body
   11.1. Removal and installation of a skeleton of a motor compartment
   + 11.2. A forward door
   + 11.3. A back door
   - 11.4. Seats
      11.4.1. Removal and installation of a forward seat
      11.4.2. Dismantling of a forward seat
      11.4.3. Removal and installation of a back seat
   + 11.5. Seat belts
   11.6. Removal and installation of the panel of devices
   11.7. Removal and tjagovo-drawbar installation
   + 11.8. A heater
+ 12. Electroschemes


Что такое артрит симптомы признаки и методы лечения


11.4.2. Dismantling of a forward seat
THE GENERAL DATA

Removal of the lever of adjustment of a seat on height

 1 – the lever;

2 – bolts;

3 – заглушки

Dismantling of a forward seat

 1 – the handle of adjustment of an inclination of a back;

2 – the screw;

3 – the left lateral facing;

4 – a ware box;

5 – the right lateral facing;

6 – a spring

Fastening of wires on a seat

 1 – collars;

2 – a clip;

3 – a wire

Fastening of the device of adjustment of a seat on height

 1 – the device;

2 – bolts

Fastening of a back of a seat

 1 – bolts;

2 – a back;

3 – a pillow

PERFORMANCE ORDER
1. Take out a seat from the car.
2. Shake the lever 1 (fig. Removal of the lever of adjustment of a seat on height see), preliminary having established it in the top position that the seat has occupied the top position.
3. Take out заглушки 3 and turn away bolts of 2 fastenings of the lever of adjustment of a seat on height.
4. Remove the lever of 1 adjustment of a seat on height.
5. Remove the handle 1 (fig. Dismantling of a forward seat see) adjustments of an inclination of a back of a seat, having pulled it on itself.
6. Turn away four screws of 2 fastenings and remove a ware box 4 under a seat.
7. Turn away screws of 2 fastenings and remove from a seat lateral facings 3 and 5.
8. For the models equipped with lateral pillows of safety and heating, depending on a complete set take out колодки with wires from the holder 6 (fig. Connecting колодки a forward seat see) and disconnect колодку with wires of a regulator 5 heatings. Cut plastic collars of 4 fastenings of wires. Cut collars 1 (Fastening of wires fig. see a seat) with a seat side.
9. Disconnect two springs 6 (fig. Dismantling of a forward seat see) from a seat skeleton.
10. Turn away three bolts 2 (fig. Fastening of the device of adjustment of a seat on height) fastenings see and remove the device of 1 adjustment of a seat on height.
11. Turn on on two bolts 1 (fig. Fastening of a back of a seat) fastenings from both parties of a seat see and remove a back 2 from a seat.
12. Collect a seat upside-down, having pressed a collar 1 (Fastening of wires fig. see a seat) a clip 2, as is shown in drawing.