Skoda Fabia

Since 2000 of release

Repair and car operation



Shkoda Fabija
+ 1.1. The car description
+ 2. The engine
+ 3. Greasing system
+ 4. The power supply system
+ 5. Cooling system
+ 6. System of release of the fulfilled gases
+ 7. Transmission and a running gear
+ 8. A steering
+ 9. Brake system
- 10. An electric equipment
   10.1. Removal and installation of the block of safety locks
   10.2. The storage battery
   + 10.3. Ignition system
   10.4. Removal and installation of a combination of devices
   + 10.5. A cleaner and a windscreen washer
   + 10.6. A cleaner and a washer of glass of a door of a back
   10.7. Replacement of lamps
   10.8. Removal and headlight installation
   10.9. Removal and installation of a back lantern
   10.10. Replacement of an additional lantern of a signal of braking
   10.11. Switches and switches
   10.12. Removal and installation of sound signals
   10.13. Removal and installation динамиков
   10.14. Removal and aerial installation
+ 11. A body
+ 12. Electroschemes


Годування щенят



10.11. Switches and switches
THE GENERAL DATA

ПОДРУЛЕВОЙ THE SWITCH


Removal подрулевого the switch

1 – подрулевой the switch;

2 – a coupling bolt

Position adjustment подрулевого the switch

1 – a steering wheel;

2 – a returnable ring;

3 – подрулевой the switch;

4 – a coupling bolt

Removal and installation

PERFORMANCE ORDER
1. Disconnect a wire from the plug - the storage battery.
2. Remove a steering wheel (subsection 8.1 see).
3. Remove returnable and contact rings (subsection 8.2 see).
4. Disconnect two колодки with wires from подрулевого the switch 1 (fig. Removal подрулевого the switch see).
5. Ослабьте an inhaling of a coupling bolt 2.
6. Remove the steering switch from a steering column.
7. Establish the switch on a steering column, without tightening a coupling bolt, and connect to it колодки with wires.
8. Establish returnable both contact rings and a steering wheel.
9. Level the switch in horizontal position.
10. Adjust switch position so that the size and (fig. position Adjustment подрулевого the switch see) made 2,5 mm, and tighten a coupling bolt 4.
11. Establish casings of a steering column.

SWITCHES ON THE PANEL OF DEVICES

Switch removal on the panel of devices

1 – a screw-driver;

2 – the switch

Removal and installation

PERFORMANCE ORDER
1. Disconnect a wire from the plug - the storage battery.
2. Accurately having hooked a screw-driver 1 (switch Removal fig. see the panel of devices) on the left side, take out the switch 2 of the panel of devices.
3. Disconnect from the switch колодку with wires.
4. At switch installation press it so that it was fixed in the panel of devices.

THE ALARM SYSTEM SWITCH

Removal of the switch of the alarm system

1 – the central nozzles;

2 – the switch

Removal and installation

PERFORMANCE ORDER
1. Disconnect a wire from the plug - the storage battery.
2. Remove from the panel of devices the central nozzles (subsection 11.8 see).
3. Take out the switch 2 (fig. Removal of the switch of the alarm system see) of the central snuffled 1.
4. Establish the switch upside-down.

THE SWITCH OF THE ELECTRIC DRIVE OF EXTERNAL MIRRORS

Removal and installation of the switch of the electric drive of external mirrors

1 – a decorative overlay;

2 – the switch

Removal and installation

PERFORMANCE ORDER
1. Disconnect a wire from the plug - the storage battery.
2. Having hooked a screw-driver, remove a decorative overlay 1 (fig. Removal and installation of the switch of the electric drive of external mirrors see) together with the switch 2.
3. Disconnect from the switch колодку with wires.
4. Having unclenched clamps, take out the switch from a decorative overlay.
5. Establish the switch upside-down.

THE LATERAL CONSOLE

Removal of the lateral console

1 – a decorative overlay;

2 – the lateral console with switches;

3 – screws

Removal and installation

PERFORMANCE ORDER
1. Disconnect a wire from the plug - the storage battery.
2. Having hooked a screw-driver, remove a decorative overlay 1 (fig. Removal of the lateral console see) together with the lateral console 2.
3. Disconnect колодку with wires from the lateral console 2.
4. Turn away screws 3 and remove a decorative overlay 1 from the lateral console 2.
5. Establish the lateral console upside-down.

THE PANEL OF THE CENTRAL SWITCH OF LIGHT

Removal of the panel of the central switch of light

1 – the panel;

2 – the handle of the central switch of light

Removal of the block of switches of the proof-reader of headlights and illumination of devices
1 – a latch;

2 – the block of switches;

3 – the central switch of light
Removal and installation

PERFORMANCE ORDER
1. Disconnect a wire from the plug - the storage battery.
2. Establish the handle 2 (fig. Removal of the panel of the central switch of light see) in position 0.
3. Drown the handle 2, turn it in vertical position and take out on itself the panel with switches.
4. Disconnect two колодки with wires.
5. To remove the block 2 (fig. Removal of the block of switches of the proof-reader of headlights and illumination of devices) switches of the proof-reader of light of headlights see and illumination of devices, wring out a plastic latch 1.
6. Establish the panel of the central switch upside-down.