Skoda Fabia

Since 2000 of release

Repair and car operation



Shkoda Fabija
+ 1.1. The car description
+ 2. The engine
+ 3. Greasing system
+ 4. The power supply system
+ 5. Cooling system
+ 6. System of release of the fulfilled gases
+ 7. Transmission and a running gear
+ 8. A steering
+ 9. Brake system
- 10. An electric equipment
   10.1. Removal and installation of the block of safety locks
   10.2. The storage battery
   + 10.3. Ignition system
   10.4. Removal and installation of a combination of devices
   + 10.5. A cleaner and a windscreen washer
   + 10.6. A cleaner and a washer of glass of a door of a back
   10.7. Replacement of lamps
   10.8. Removal and headlight installation
   10.9. Removal and installation of a back lantern
   10.10. Replacement of an additional lantern of a signal of braking
   10.11. Switches and switches
   10.12. Removal and installation of sound signals
   10.13. Removal and installation динамиков
   10.14. Removal and aerial installation
+ 11. A body
+ 12. Electroschemes





10.7. Replacement of lamps
THE GENERAL DATA

LAMPS DISTANT AND THE PASSING LIGHT

Removal of a cover of a headlight

1 – a clamp;

2 – a cover

Replacement of a lamp of a headlight

1 – connecting колодка;

2 – a lamp;

3 – a spring clamp

Arrangement of lamps in a headlight

1 – a headlight lamp;

2 – a passing light lamp;

3 – a lamp of dimensional light

The prevention

Galogenovye lamps at work heat up to a heat. Do not concern flasks of a lamp with hands: on it there are fatty traces because of which the lamp will quickly fuse. If you have unintentionally concerned flasks, wipe its pure rag moistened with spirit.


PERFORMANCE ORDER
1. For convenience of work with the left headlight remove a lateral cover of the storage battery.
2. Disconnect a wire from the plug - the storage battery.
3. Having pressed two spring clamps 1 (fig. Removal of a cover of a headlight see), uncover 2 headlights.
4. Disconnect колодку 1 (fig. Replacement of a lamp of a headlight see) with wires from a cartridge of a lamp of a headlight.
5. Deduce the ends of a spring clamp 3 from hooks on the case of a headlight and turn a clamp aside.
6. Take out a lamp 2 headlights.
7. Insert a new lamp, without concerning with fingers of a glass flask. Thus ledges on the headlight case should enter into apertures on a lamp socle.
8. Turn a spring clamp into place and hook on its ends for hooks on the headlight case. Then connect to a lamp cartridge колодку with wires.
9. Establish into place and fix a headlight cover.
10. A lamp 2 (fig. the Arrangement of lamps in a headlight see) passing light replace the same as a headlight lamp.

LAMP OF DIMENSIONAL LIGHT

PERFORMANCE ORDER
1. Disconnect a wire from the plug - the storage battery.
2. Having pressed two spring clamps 1 (fig. Removal of a cover of a headlight see), uncover 2 headlights.
3. Having pulled on itself, take out a cartridge with a lamp 3 (fig. the Arrangement of lamps in a headlight see) dimensional light from the headlight case.
4. Take out a lamp of dimensional light from a cartridge, insert a new lamp and establish a cartridge into place.
5. Establish into place and fix a headlight cover.

LAMP OF THE FORWARD INDEX OF TURN

Replacement of a lamp of the forward index of turn

1 – a cartridge;

2 – the case of the index of turn;

3 – a headlight

PERFORMANCE ORDER
1. Disconnect a wire from the plug - the storage battery.
2. Take out a cartridge 1 (fig. Replacement of a lamp of the forward index of turn see) with a lamp from the case 2 indexes of turn, having turned it counter-clockwise.
3. Press a lamp, turn it counter-clockwise and take out from a cartridge.
4. Insert a new lamp into a cartridge and fix it, having turned clockwise against the stop.

LAMP OF THE ANTIFOG HEADLIGHT

Removal of a ventilating lattice

1 – an antifog headlight;

2 – a ventilating lattice;

3 – the forward buffer

Removal of an antifog headlight

1 – an antifog headlight;

2 – screws;

3 – the gauge of temperature of air

Replacement of a lamp of an antifog headlight

1 – an antifog headlight;

2 – the gauge of temperature of air;

3 – a spring clamp;

4 – a wire tip;

5 – a lamp

PERFORMANCE ORDER
1. Disconnect a wire from the plug - the storage battery.
2. By means of a screw-driver wring out two clamps in the places specified by arrows on fig. Removal of a ventilating lattice, a ventilating lattice 2 (since the clamp nearest to the centre) and remove a lattice 2 from the forward buffer.
3. Turn away screws 2 (fig. Removal of an antifog headlight see) headlight fastenings. Pay attention that the top screw of the left headlight крепит also the gauge of 3 temperatures of air.
4. Take out a headlight 1 (fig. Replacement of a lamp of an antifog headlight) from the buffer see and remove заглушку.
5. Disconnect a tip of 4 wires.
6. Deduce the ends of a spring clamp 3 from hooks on the case of a headlight and turn a clamp aside.
7. Take out a lamp 5 with a wire.
8. Insert a new lamp, without concerning with fingers of a glass flask. Thus ledges on the headlight case should enter into apertures on a lamp cartridge.
9. Turn a spring clamp into place, hook on its ends for hooks on the case of a headlight and connect to колодке with a wire. Establish заглушку.
10. Establish into place an antifog lantern and a ventilating lattice.

LAMPS OF THE BACK LANTERN (THE BODY THE HATCHBACK)

Removal of the holder of lamps of a back lantern

1 – latches;

2 – the holder of lamps;

3 – a lantern

The holder with lamps of a back lantern

1 – a lamp of a signal of braking;


2 – a lamp of the index of turn;


3 – a lamp of light of a backing;


4 – a lamp of dimensional light (in the left lantern it is also an antifog lamp);


5 – the holder of lamps
PERFORMANCE ORDER
1. Disconnect a wire from the plug - the storage battery.
2. Open a door of a back and cast away upholstery edge to get access to a lantern 3 (fig. Removal of the holder of lamps of a back lantern see).
3. Compress two plastic latches 1 on the top part of the holder of 2 lamps that they left gearing with the lantern case.
4. Take out the holder of 2 lamps from the lantern case.
5. Press fused lamp, turn it counter-clockwise and take out from the holder 5 (fig. the Holder with lamps of a back lantern see).
6. Insert a new lamp in the holder and fix it, having turned clockwise against the stop.
7. Insert into the lantern case at first the bottom part of the holder, then top, having fixed the holder in the case. Clicks should be thus audible.
8. Establish an upholstery into place.

LAMPS OF THE BACK LANTERN (THE BODY THE SEDAN AND THE VERSATILE PERSON)

Kind from a luggage carrier on a back lantern of bodies a sedan and the versatile person

1 – a back lantern;

2 – the holder of lamps

PERFORMANCE ORDER
1. Disconnect a wire from the plug - the storage battery.
2. Open a luggage carrier cover.
3. Accurately uncover the luggage carrier upholstery, closing access to a lantern 1 (fig. the Kind from a luggage carrier on a back lantern of bodies a sedan and the versatile person see).
4. Turn away screws of fastening and take out the holder of 2 lamps from the lantern case.
5. Press fused lamp, turn it counter-clockwise and take out from the holder.
6. Insert a new lamp in the holder and fix it, having turned clockwise against the stop.
7. Establish the holder in the case of a headlight and fix its screws.
8. Establish into place an upholstery cover.

LAMP OF THE LANTERN OF ILLUMINATION OF LICENSE PLATE

Fastening of a lantern of illumination of licence plate

1 – screws;

2 – a lantern;

3 – a luggage carrier cover

PERFORMANCE ORDER
1. Disconnect a wire from the plug - the storage battery.
2. Open a luggage carrier cover.
3. Turn away two screws 1 (fig. Fastening of a lantern of illumination of licence plate see) fastenings of a lantern of illumination of licence plate.
4. Take out a lantern 2 of a luggage carrier cover.
5. Take out a lamp and insert the new.
6. Establish a lantern into place so that the rubber sealant was located exactly, without folds. Fix a lantern screws.

LAMPS OF THE PLAFOND OF ILLUMINATION OF SALON AND DIRECTIONAL LIGHT

Plafond of illumination of salon

1 – рассеиватель;

2 – a ceiling upholstery

PERFORMANCE ORDER
1. Disconnect a wire from the plug - the storage battery.
2. Accurately having hooked a screw-driver in a forward part (it is specified by an arrow), remove рассеиватель 1 (see fig. the Plafond of illumination of salon).
3. Take out a lamp of a plafond of illumination of salon and insert the new.
4. For replacement of a lamp of a directional light take out it from a cartridge and establish the new.
5. Establish рассеиватель upside-down and fix it in a ceiling upholstery.

LAMP OF THE PLAFOND OF ILLUMINATION OF THE LUGGAGE CARRIER (THE BODY THE HATCHBACK AND THE VERSATILE PERSON)

Removal of a plafond of illumination of a luggage carrier (a body a hatchback and the versatile person)


PERFORMANCE ORDER
1. Disconnect a wire from the plug - the storage battery.
2. Open a door of a back and remove a back shelf.
3. Accurately having hooked a screw-driver in a place specified by an arrow on fig. Removal of a plafond of illumination of a luggage carrier (a body a hatchback see and the versatile person), take out a plafond from a luggage carrier upholstery.
4. Disconnect from a wire plafond.
5. Take out a lamp and insert the new.
6. Connect to a wire plafond.
7. Establish in an upholstery at first a forward part of a plafond, and then, having pressed a back part, fix it.

LAMP OF THE PLAFOND OF ILLUMINATION OF THE LUGGAGE CARRIER (THE BODY THE SEDAN)

Removal of a plafond of illumination of a luggage carrier (a body a sedan)

1 – a plafond;

2 – connecting колодка;

3 – a clamp of the case of a plafond;

4 – the plafond case


PERFORMANCE ORDER
1. Disconnect a wire from the plug - the storage battery.
2. Open a back door.
3. Accurately having hooked a screw-driver in a place specified by an arrow on fig. Removal of a plafond of illumination of a luggage carrier (a body a sedan), take out a plafond 1.
4. Disconnect from a plafond 1 колодку 2 with wires.
5. Wring out a clamp 3 and remove the case 4 plafonds.
6. Take out a lamp and insert the new.
7. Establish the case and connect to a plafond колодку with wires.
8. Establish in an upholstery at first a back part of a plafond, and then, having pressed a forward part, fix it.

LAMP OF THE PLAFOND OF ILLUMINATION OF THE WARE BOX

Removal of a plafond of illumination of a ware box


PERFORMANCE ORDER
1. Disconnect a wire from the plug - the storage battery.
2. Open a cover of a ware box.
3. Accurately having hooked a screw-driver in a place specified by an arrow on fig. Removal of a plafond of illumination of a ware box, take out a plafond.
4. Having pressed clamps, disconnect from a plafond колодку with wires.
5. Take out a lamp and insert the new.
6. Connect to a plafond колодку with wires.
7. Accurately press a plafond into a lateral wall of a ware box, since its bottom part.

LAMP OF THE ALARM LANTERN AT DOORS

Replacement of a lamp of an alarm lantern at doors

1 – a lantern;

2 – колодка

PERFORMANCE ORDER
1. Disconnect a wire from the plug - the storage battery.
2. Accurately having hooked a screw-driver, take out a lantern 1 (fig. Replacement of a lamp of an alarm lantern at doors see) of a door.
3. Disconnect from a lantern колодку 2 with wires.
4. Take out a lamp and insert the new.
5. Connect to a lantern колодку with wires.
6. Accurately press a lantern into a door.

LAMP OF THE LATERAL REPEATER OF THE INDEX OF TURN

Details of the lateral repeater of the index of turn

1 – the repeater case;

2 – a lamp;

3 – a protective cover;

4 – a lining

PERFORMANCE ORDER
1. Disconnect a wire from the plug - the storage battery.
2. Turn away two screws of fastening локаря in the wheel niches shown by arrows on fig. of the Detail of the lateral repeater of the index of turn.
3. From the interior of a wing compress plastic latches and push out the repeater outside.
4. Remove the case 1 from a protective cover 3.
5. Replace a lamp 2 and establish on a cover 3 case 1.
6. Establish the repeater in an aperture of a wing and press it to a wing so that it was fixed. Thus pay attention that wider latch of the case 1 should be directed towards a forward part of the car.