Skoda Fabia

Since 2000 of release

Repair and car operation



Shkoda Fabija
+ 1.1. The car description
+ 2. The engine
+ 3. Greasing system
+ 4. The power supply system
+ 5. Cooling system
+ 6. System of release of the fulfilled gases
+ 7. Transmission and a running gear
+ 8. A steering
+ 9. Brake system
- 10. An electric equipment
   10.1. Removal and installation of the block of safety locks
   10.2. The storage battery
   - 10.3. Ignition system
      10.3.1. Safety precautions regulations
      10.3.2. Removal and installation of the module of ignition
      10.3.3. Check and replacement of spark plugs
      10.3.4. Check of a feed circuit of the module of ignition
      10.3.5. Check of resistance of a secondary chain of the module of ignition
      10.3.6. The gauge of position of a cam-shaft of engines of 1,0 l, 37 kw and 1,4 l, 50 kw
      10.3.7. The gauge of frequency of rotation коленвала engines of 1,0 l, 37 kw, 1,4 l, 50 kw
      10.3.8. The gauge of position of a cam-shaft of engines of 1,4 l, 55 and 74 kw
   10.4. Removal and installation of a combination of devices
   + 10.5. A cleaner and a windscreen washer
   + 10.6. A cleaner and a washer of glass of a door of a back
   10.7. Replacement of lamps
   10.8. Removal and headlight installation
   10.9. Removal and installation of a back lantern
   10.10. Replacement of an additional lantern of a signal of braking
   10.11. Switches and switches
   10.12. Removal and installation of sound signals
   10.13. Removal and installation динамиков
   10.14. Removal and aerial installation
+ 11. A body
+ 12. Electroschemes





10.3.8. The gauge of position of a cam-shaft of engines of 1,4 l, 55 and 74 kw
THE GENERAL DATA

The gauge of position of a camshaft of engines of 1,4 l, 55 and 74 kw

1 – the gauge;

2 – connecting колодка

Check

PERFORMANCE ORDER
1. Preliminary check up pressure of the storage battery. It should be not less than 11,5 Century
2. Remove the top casing of the engine (subsection 2.1 see).
3. Disconnect колодку 2 (fig. the Gauge of position of a camshaft of engines of 1,4 l, 55 and 74 kw see) with wires from the gauge 1.
4. Connect the voltmeter to contacts 1 and 3 колодки 2.
5. Include ignition. The voltmeter should show pressure not less than 4,5 Century
6. If the voltmeter shows 0, check up wires on breakage and short circuit.
7. If there is no breakage or short circuit in wires, and the voltmeter shows pressure not less than 4,5 In, replace the gauge of position of a camshaft.
8. If there is no breakage or short circuit in wires, and the voltmeter shows 0, replace the engine management block.