Skoda Fabia

Since 2000 of release

Repair and car operation

11.8.10. Removal and heater installation

THE GENERAL DATA

Removal of the right support of an arm of the panel of devices

1 – the right support; 2, 4 – bolts; 3 – an adapter of the bottom air line

Air line fastening обдува feet of the driver

1 – a bolt of fastening of an air line; 2 – an air line обдува feet of the driver; 3 – the block of management of system "Comfort"; 4 – a bolt

Heater fastening on the right side

1 – an arm of the panel of devices; 2 – a bolt; 3 – connecting колодка the additional resistor

PERFORMANCE ORDER

1. Disconnect a wire from the plug - the storage battery. 2. Merge a liquid from system of cooling of the engine or press taking away 1 and bringing 2 (fig. Connection of hoses to a heater radiator see) hoses of a radiator of a heater (if a heater radiator remove for replacement, it is necessary to merge a liquid). 3. From outside a motor compartment mark position of a branch pipe 4 radiators of a heater and turn away a bolt of 5 its fastenings. Take out a branch pipe and together with hoses put aside. 4. Muffle apertures in a heater radiator. 5. Remove the floor console. 6. Remove the panel of devices (subsection 11.6 see). 7. Remove an air line 24 (fig. heater Elements see) обдува a windscreen. 8. Remove воздуходув 6 central snuffled. 9. Disconnect a plait of wires from a support 1 (fig. Removal of the right support of an arm of the panel of devices see) arm of the panel of devices and "a mass" wire. 10. Turn away two top 4 and one bottom 2 bolt of fastening and remove the right support of 1 arm of the panel of devices. 11. Remove an adapter 3 bottom air lines. 12. Disconnect колодку 4 (fig. Removal of the fan of a heater see) with wires from the heater fan. 13. Remove the control panel a heater, having disconnected from it колодку with wires and drive cables (subsection 11.8.7 see). 14. Turn away a bolt 1 (fig. air line Fastening обдува feet of the driver) fastenings see and remove an air line 2 обдува feet of the driver. 15. Shift upwards an arm of fastening and remove it with the block of 3 managements of system "Comfort" (if it is established) from a heater casing. 16. On models with an electroheating element 2 (fig. a heater Radiator see) disconnect колодку 11 with wires from a plait on the left side of a heater and "a mass" wire 10. 17. Turn away three bolts 4 (fig. air line Fastening обдува feet of the driver see) heater fastenings on the left side. 18. Disconnect колодку 3 (fig. heater Fastening on the right side see) from the additional resistor of a heater. 19. Turn away two bolts of 2 fastenings of a heater on the right side. 20. Remove a heater from the car. 21. Establish a heater upside-down. Before installation of the panel of devices check up correctness of work of a heater. Establish branch pipes according to earlier made marks, densely having inserted them into a sealant on a board передка. 22. Check up level and if necessary add cooling liquid (at replacement of a radiator of a heater fill in a new liquid in system of cooling of the engine).

The inhaling moments, Нм

Bolt of fastening of a branch pipe of a radiator of a heater	20
Bolts of the top fastening of a support of an arm of the panel of devices	12
Bolt of the bottom fastening of a support of an arm of the panel of devices	25