Skoda Fabia

Since 2000 of release

Repair and car operation

7.3.2. Removal and installation of a nave of a wheel (the disk brake mechanism)

THE GENERAL DATA

---

The prevention

At an exit of the bearing of a nave out of operation it is recommended to replace the bearing in gathering with a nave.

---

PERFORMANCE ORDER

1. Cautiously bring down a protective cap 5 (fig. of the Detail of a back suspension bracket with disk brakes) nuts of a nave see and remove it. 2. Ослабьте an inhaling of a nut of 6 naves (a nut двенадцатигранная) and bolts of 2 fastenings of a wheel. 3. Lift and establish on reliable support a back part of the car. 4. Remove a wheel, having turned on definitively bolts of its fastening. 5. Turn away two bolts of 16 fastenings and remove from a flange of a beam of a back suspension bracket directing 1 колодок in gathering with a support. Suspend directing 1 колодок on a wire to a suspension bracket spring, watching that the brake hose did not stretch, it was not overwound and strongly it was not bent. 6. Turn out the screw of 3 fastenings of a brake disk. 7. Remove a brake disk 4 from a nave. At the complicated removal shift a disk a rubber or polymeric hammer. 8. Definitively turn away a nut of 6 naves. 9. Cautiously, without warping, remove a nave 7 from a pin. 10. Напрессуйте a nave 7 on a pin 15, without supposing перекашивания a nave. 11. Screw a new nut of 6 naves. Definitively tighten a nave nut on the car standing on the earth. 12. Establish a brake disk and a wheel. 13. Necessarily replace the broken or deformed cap of 5 naves.

The inhaling moments, Нм

Nut of a nave of a wheel	70, then to tighten on 30
The screw of fastening of a brake disk	4
Bolts of fastening of a wheel	120