Skoda Fabia

Since 2000 of release

Repair and car operation



Shkoda Fabija
+ 1.1. The car description
+ 2. The engine
+ 3. Greasing system
+ 4. The power supply system
+ 5. Cooling system
+ 6. System of release of the fulfilled gases
+ 7. Transmission and a running gear
- 8. A steering
   8.1. Removal and steering wheel installation
   8.2. Removal and installation of returnable and contact rings in gathering
   + 8.3. A steering column
   + 8.4. The steering mechanism (without the amplifier)
   - 8.5. The steering mechanism (with the amplifier)
      8.5.1. Replacement of a tip of steering draught
      8.5.2. Removal of the steering mechanism
      8.5.3. Installation of the steering mechanism
      8.5.4. Replacement of steering draught
      8.5.5. The pump unit
      8.5.6. Check of electric chains of the amplifier of a steering
      8.5.7. Replacement of the gauge of the amplifier of a steering
      8.5.8. Replacement of highways of system of the amplifier of a steering
      8.5.9. Check of level of a working liquid
      8.5.10. Refuelling and removal of air from hydraulic system
      8.5.11. Check and adjustment of corners of installation of wheels
+ 9. Brake system
+ 10. An electric equipment
+ 11. A body
+ 12. Electroschemes





8.5.3. Installation of the steering mechanism
THE GENERAL DATA

Details of the steering mechanism (with the amplifier)
1 – a tip;
2 – a counternut;
3 – an external collar;
4 – a protective cover;
5 – an internal collar;
6 – a bolt;
7 – теплоизоляционный the screen;
8 – steering draught;
9 – a pillow;
10 – fixing скоба;
11 – a sealant;
12 – картер the steering mechanism;
13 – a shaft приводной gear wheels of the steering mechanism;
14 – a lining;
15 – the gauge of the amplifier of a steering;
16 – a bolt of fastening of the gauge of the amplifier of a steering;
17 – рейка the steering mechanism

PERFORMANCE ORDER
1. Check up and, if necessary, adjust position рейки the steering mechanism (subsection 8.4.4 see).
2. Grease with a soap solution a pillow 9 (fig. of the Detail of the steering mechanism (with the amplifier see)) support of the steering mechanism to facilitate installation on it fixing скобы 10.
3. Establish the steering mechanism 22 (Fastening of the steering mechanism fig. see the car (with the amplifier)) on a beam 21 forward suspension brackets and screw new bolts of 18 its fastenings, definitively without tightening them.
4. Check up correctness of installation of a sealant 11 (fig. of the Detail of the steering mechanism (with the amplifier see)) on the case of the steering mechanism.
5. Cautiously lift a beam so that it was possible to connect highways and the gauge to the steering mechanism, having entered thus into a board aperture передка a shaft приводной gear wheels of the steering mechanism.
6. Connect the gauge 6 (Fastening of the steering mechanism fig. see the car (with the amplifier)) the amplifier to the steering mechanism, having established a new lining 5, and fix two bolts 7 with internal шестигранниками.
7. Connect to картеру the steering mechanism pressure head 16 and returnable 12 highways, using thus new sealing rings 13 and 15. Pay attention, at a returnable highway a sealing ring of round section.
8. Fix a beam of a forward suspension bracket.
9. Tighten the corresponding moment new bolts of 18 fastenings of the steering mechanism to a beam of a forward suspension bracket.
10. Connect steering bent for to rotary levers.
11. Connect racks to a bar of the stabilizer of cross-section stability and screw up fastening nuts.
12. Attach a back support 20 to a transmission two new bolts 19.
13. On models with the reception pipe of the muffler which are passing under a beam of a forward suspension bracket, establish a reception pipe with neutralizer.
14. Establish грязезащитный a guard and forward wheels.
15. Lower the car on wheels.
16. Fix a wire of the gauge of the amplifier of a steering in three holders 4 (fig. Elements of the hydraulic amplifier of a steering see).
17. Put on a shaft приводной gear wheels of the steering mechanism a plug 3 (Fastening of the steering mechanism fig. see the car (with the amplifier)) карданного the hinge and fix a plug a new coupling bolt 4.
18. Insert into a board aperture передка a sealant 11 (fig. of the Detail of the steering mechanism (with the amplifier see)). Be convinced that it has settled down exactly and densely.
19. Establish a casing 2 (fig. casing Fastening карданного a shaft of a steering column) карданного a shaft of a steering column see and fix its two plastic nuts 1.
20. Fill in a working liquid in hydraulic system of the amplifier of a steering (subsection 8.5.10 see).
21. Establish into place the storage battery.
22. Establish the air filter if it removed.
23, Check up and, if necessary, adjust corners of installation of wheels.
24. It is recommended to check up at servicing deport work of an electric part of system of the amplifier of a steering by means of the special electronic device.

The inhaling moments, Нм

Bolts of fastening of the steering mechanism to a beam of a forward suspension bracket
50, then to tighten on 90
Bolts of fastening of a back support to a transmission
30, then to tighten on 90
Nuts of fastening of a bar of the stabilizer of cross-section stability to racks
40
Bolts of fastening of the gauge of the amplifier of a steering
6
Hollow bolt of fastening of a pressure head highway to картеру the steering mechanism
35
Nut of fastening of a returnable highway to картеру the steering mechanism
30
Coupling bolt of a plug карданного the hinge
20, then to tighten on 90
Fastening bolts теплоизоляционного the screen
10
Bolts of fastening of a wheel
120