Skoda Fabia

Since 2000 of release

Repair and car operation


Shkoda Fabija
+ 1.1. The car description
+ 2. The engine
+ 3. Greasing system
+ 4. The power supply system
+ 5. Cooling system
+ 6. System of release of the fulfilled gases
+ 7. Transmission and a running gear
+ 8. A steering
- 9. Brake system
   - 9.1. Pedal knot
      9.1.1. Removal and installation
      9.1.2. Replacement of plugs of a pedal of a brake
   9.2. The vacuum amplifier
   9.3. The main brake cylinder
   9.4. A pressure regulator (on models without ABS)
   + 9.5. The brake mechanism of a forward wheel of type FS III
   + 9.6. The brake mechanism of a forward wheel of type FS II
   + 9.7. The brake mechanism of a back wheel (drum-type)
   + 9.8. The brake mechanism of a back wheel (disk)
   + 9.9. A lay brake
   + 9.10. Antiblocking system (ABS)
+ 10. An electric equipment
+ 11. A body
+ 12. Electroschemes





9.1.2. Replacement of plugs of a pedal of a brake
THE GENERAL DATA

Fastening of an axis of a pedal of a brake

 1 – a brake pedal;

2 – a nut of fastening of an axis;

3 – an axis of a pedal of a brake;

4 – an arm

Pedal of a brake with plugs

 1 – a brake pedal;

2 – the plastic plug;

3 – the axis plug

PERFORMANCE ORDER
1. Disconnect a wire from the plug - the storage battery.
2. Remove a ware box from outside the driver.
3. Turn away a bolt of fastening and remove an air line обдува feet of the driver (subsection 11.6 see). On the models equipped with system "Comfort", remove the central block of management.
4. Remove the switch of a signal of braking (subsection 9.10.7 see).
5. Disconnect колодку from the gauge of position of a pedal of an accelerator.
6. Disconnect a pedal of a brake from a pusher of the vacuum amplifier (subsection 9.1 see).
7. Turn away a nut 2 (fig. Fastening of an axis of a pedal of a brake see) fastenings of an axis of a pedal of a brake.
8. Take out an axis 3, and then a pedal of 1 brake from an arm 4.
9. Take out the plug 3 (fig. the Pedal of a brake with plugs see) axes from a pedal 1.
10. Take out two plastic plugs 2 of a pedal 1.
11. Insert against the stop without a warp two new plugs 2 into a pedal of 1 brake.
12. Insert the plug of 3 axes, preliminary having greased its cavity консистентной with greasing.
13. Establish a pedal of 1 brake upside-down. Thus latch a pedal 3 (fig. Connection of a pedal of a brake to a pusher of the vacuum amplifier see) brakes on a spherical tip of a pusher of 1 vacuum amplifier.

The moment of an inhaling of a nut of fastening of an axis of a pedal of a brake – 28 Нм.