Skoda Fabia

Since 2000 of release

Repair and car operation


Shkoda Fabija
+ 1.1. The car description
+ 2. The engine
+ 3. Greasing system
+ 4. The power supply system
- 5. Cooling system
   5.1. Check of tightness of system of cooling
   5.2. Check of a stopper of a broad tank
   5.3. Removal and radiator installation on models without the conditioner
   5.4. Removal and radiator installation on models with the conditioner
   5.5. Removal and installation of the water pump on models with petrol engines
   5.6. Removal and installation of the water pump on models with diesel engines
   5.7. Removal and installation of the fan of a radiator
   5.8. Replacement of the gauge of inclusion of the fan
   5.9. Removal and thermostat installation
   5.10. Thermostat check
   5.11. Replacement of hoses of system of cooling of the engine
   5.12. Check of level of a cooling liquid
   5.13. Replacement of a cooling liquid
+ 6. System of release of the fulfilled gases
+ 7. Transmission and a running gear
+ 8. A steering
+ 9. Brake system
+ 10. An electric equipment
+ 11. A body
+ 12. Electroschemes


https://www.magicalescorts.com/ Интересное


5.3. Removal and radiator installation on models without the conditioner
THE GENERAL DATA

Connecting колодки the gauge of inclusion of the fan and the fan electric motor

1 – connecting колодка the gauge of inclusion of the fan;

2 – connecting колодка the fan electric motor;

3 – a tip of a taking away hose of a radiator;

4 – a tip clamp


PERFORMANCE ORDER
1. Disconnect a wire from the plug - the storage battery.
2. Merge cooling liquid (subsection 5.13 see).
3. Having pressed uvulas of clamps, disconnect колодки 1 and 2 with wires from the gauge of inclusion of the fan and the fan electric motor (fig. Connecting колодки the gauge of inclusion of the fan and the fan electric motor see).
4. Having wrung out a spring clamp 4, disconnect from a radiator branch pipe taking away (bottom) hose with a tip 3. In the same way disconnect from a radiator bringing hose.
5. Remove the forward buffer.
6. Remove a skeleton of a motor compartment in gathering with a radiator (subsection 11.1 see).
7. Turn away bolts of fastening and remove a radiator in gathering with a casing 7 (fig. the Radiator of system of cooling see) fan.
8. If necessary turn away screws 8 and remove a casing 7 from a radiator 1.
9. Replace the sealing rings torn or lost elasticity 2.
10. Establish a radiator upside-down. Thus pay attention that the top support 19 radiators of white colour, and bottom 17 – black.
11. After installation fill in cooling liquid. The moment of an inhaling of bolts of fastening of a radiator 5 Нм.