Skoda Fabia

Since 2000 of release

Repair and car operation



Shkoda Fabija
+ 1.1. The car description
+ 2. The engine
+ 3. Greasing system
+ 4. The power supply system
- 5. Cooling system
   5.1. Check of tightness of system of cooling
   5.2. Check of a stopper of a broad tank
   5.3. Removal and radiator installation on models without the conditioner
   5.4. Removal and radiator installation on models with the conditioner
   5.5. Removal and installation of the water pump on models with petrol engines
   5.6. Removal and installation of the water pump on models with diesel engines
   5.7. Removal and installation of the fan of a radiator
   5.8. Replacement of the gauge of inclusion of the fan
   5.9. Removal and thermostat installation
   5.10. Thermostat check
   5.11. Replacement of hoses of system of cooling of the engine
   5.12. Check of level of a cooling liquid
   5.13. Replacement of a cooling liquid
+ 6. System of release of the fulfilled gases
+ 7. Transmission and a running gear
+ 8. A steering
+ 9. Brake system
+ 10. An electric equipment
+ 11. A body
+ 12. Electroschemes





5.7. Removal and installation of the fan of a radiator
THE GENERAL DATA

If it is found out люфт in bearings of the electric motor or deformation of blades крыльчатки, replace the fan as the electric motor works with very big frequency of rotation of an anchor and any infringement of balancing can lead to fan destruction (usually at the most inappropriate moment).

PERFORMANCE ORDER
1. Disconnect a wire from the plug - the storage battery.
2. Having pressed a clamp uvula, separate колодку 2 (fig. Connecting колодки the gauge of inclusion of the fan and the fan electric motor see) with wires of the electric motor of the fan.
3. On models with the conditioner, having pressed a clamp uvula, separate колодку 5 (fig. the Radiator of system of cooling see) with wires of the electric motor of the fan of the conditioner.
4. Turn away four screws of 8 fastenings of a casing of the fan 7 to a radiator 1.
5. Cautiously remove a casing 7 in gathering with the fan.
6. Take out колодку 5 with wires of the electric motor of the fan from an arm 14 on a fan casing.
7. Remove the holder of 12 wires of the electric motor of the fan.
8. Turn away three screws of fastening and remove an arm 11 in gathering with the fan 13.
9. On models with the conditioner the additional fan 10 remove to the similarly basic fan.
10. Turn away three nuts of fastening and remove the fan 13 from an arm 11.
11. Establish the fan upside-down.

The inhaling moments, Нм

On models without the conditioner:
  – Screws of fastening of a casing of the fan to a radiator
10
  – Screws of fastening of an arm of the fan
10
  – Nuts of fastening of an arm of the fan to a casing
10
On models with the conditioner:
  – Screws of fastening of a casing of the fan to a radiator
5
  – Screws of fastening of an arm of the fan
5
  – Nuts of fastening of an arm of the fan to a casing
5