Skoda Fabia

Since 2000 of release

Repair and car operation



Shkoda Fabija
+ 1.1. The car description
+ 2. The engine
+ 3. Greasing system
+ 4. The power supply system
- 5. Cooling system
   5.1. Check of tightness of system of cooling
   5.2. Check of a stopper of a broad tank
   5.3. Removal and radiator installation on models without the conditioner
   5.4. Removal and radiator installation on models with the conditioner
   5.5. Removal and installation of the water pump on models with petrol engines
   5.6. Removal and installation of the water pump on models with diesel engines
   5.7. Removal and installation of the fan of a radiator
   5.8. Replacement of the gauge of inclusion of the fan
   5.9. Removal and thermostat installation
   5.10. Thermostat check
   5.11. Replacement of hoses of system of cooling of the engine
   5.12. Check of level of a cooling liquid
   5.13. Replacement of a cooling liquid
+ 6. System of release of the fulfilled gases
+ 7. Transmission and a running gear
+ 8. A steering
+ 9. Brake system
+ 10. An electric equipment
+ 11. A body
+ 12. Electroschemes





5.4. Removal and radiator installation on models with the conditioner
PERFORMANCE ORDER
1. Disconnect a wire from the plug - the storage battery.
2. Merge cooling liquid (subsection 5.13 see).
3. Having pressed uvulas of clamps, disconnect колодки 1 and 2 with wires from the gauge of inclusion of the fan and the fan electric motor, and also from the electric motor of the additional fan (fig. Connecting колодки the gauge of inclusion of the fan and the fan electric motor see).
4. Having taken out a spring clamp 4, disconnect taking away (bottom) hose with a tip 3 from a radiator branch pipe. In the same way disconnect from a radiator bringing hose.

The prevention

Do not open conditioner hydrosystem, i.e. do not disconnect hoses from the condenser.


5. Remove a skeleton of a motor compartment (subsection 11.1 see), having fixed a radiator with the condenser on a body. Watch, that condenser hoses were not bent strongly.

The prevention

At all do not leave to hang a radiator with the condenser on hoses.


6. Turn away four bolts of 2 fastenings of the condenser 3 to a radiator 1.
7. Remove from the car a radiator 1 (fig. the Radiator of system of cooling see) in gathering with the fan.
8. If necessary turn away screws 8 and remove a casing 7 from a radiator 1.
9. Replace the sealing rings torn or lost elasticity.
10. Establish a radiator upside-down. Thus pay attention that the top support of a radiator of white colour, and bottom – black.
11. After installation fill in cooling liquid.

The inhaling moments, Нм

Bolts of fastening of a radiator
5
Bolts of fastening of the condenser to a radiator
5