Skoda Fabia

Since 2000 of release

Repair and car operation

9.9.4. Replacement of cables

PERFORMANCE ORDER

1. Remove the floor console. 2. Raise and establish on reliable support a back part of the car. 3. Remove a wheel, preliminary having weakened bolts of its fastening on the car standing on the earth. 4. Lower the lever of a lay brake against the stop downwards. 5. Ослабьте an adjusting nut 4 (fig. Installation of the lever of a lay brake see) and disconnect tips of cables 7 from the equalizer 3. 6. Disconnect the holder 9 (fig. of the Detail of a back suspension bracket with drum-type brakes see) from a beam of a back suspension bracket. 7. Disconnect cables from spring holders 16. The drum-type brake mechanism 8. Remove a brake drum. 9. Disconnect a cable from the lever 8 (fig. of the Detail of the brake drum-type mechanism of a back wheel see) manual drive. 10. Pull out a tip of a cable from a brake board 14. 11. Take out a cable 7 (fig. Installation of the lever of a lay brake see) of a directing tube 6. The disk brake mechanism 12. Having hooked a screw-driver, remove spring скобу 1 (fig. the Detachment of a cable of a drive of a lay brake see). 13. Having wrung out the lever 6 manual drives in a direction specified by an arrow, disconnect from it a cable 4 drives of a lay brake. 14. Take out a cable 7 (fig. Installation of the lever of a lay brake see) of a directing tube 6. 15. Establish a cable upside-down. 16. Thus replace the holder 9 (fig. of the Detail of a back suspension bracket with drum-type brakes see) cable. The ring on a cable cover should be between collars of the holder 9. 17. Adjust a lay brake.