Shkoda Fabija
+ 1.1. The car description
+ 2. The engine
+ 3. Greasing system
- 4. The power supply system
4.1. Removal and installation of the air filter
4.2. Replacement of a filtering element of the air filter
4.3. Replacement of the gauge of the index of level of fuel
4.4. Removal and installation of a fuel tank
4.5. Check of the air valve
4.6. Check of the gravitational valve
4.7. Replacement of the fuel filter
4.8. Check of the valve of heating of fuel
4.9. Replacement of an adsorber of system of catching of steams of fuel
4.10. Replacement of a fuel radiator
4.11. Removal and installation of the vacuum pump of the diesel engine
4.12. Removal and installation of an inlet pipe of the engine
4.13. Removal and installation of a pedal of an accelerator
+ 4.14. Removal and installation of atomizers
4.15. Check of a feed circuit of atomizers of the petrol engine
4.16. Check of resistance of a pump-atomizer
4.17. Check of candles накаливания the diesel engine of 1,9 l, 47 kw
4.18. Check of a feed circuit of candles накаливания
4.19. Check of the gauge of temperature of a cooling liquid
4.20. Check of the gauge of temperature of air arriving in the engine
4.21. Check of the gauge of temperature of fuel of the diesel engine of 1,9 l, 74 kw
4.22. Check of the gauge of frequency of rotation of a cranked shaft
4.23. Check of a drive throttle заслонки
4.24. Check of the gauge of position of a camshaft
4.25. Check элекромагнитного the valve рециркуляции the fulfilled gases
4.26. Check of the relay of the fuel pump of engines of 1,4 l, 55 and 74 kw
4.27. Check of the electromagnetic valve of a purge of an adsorber
4.28. Removal and installation турбокомпрессора
4.29. Removal and installation of an intermediate cooler of air
4.30. Check of the valve of pressure of pressurisation
+ 5. Cooling system
+ 6. System of release of the fulfilled gases
+ 7. Transmission and a running gear
+ 8. A steering
+ 9. Brake system
+ 10. An electric equipment
+ 11. A body
+ 12. Electroschemes
|
The gauge of temperature of a cooling liquid of the engine of 1,4 l, 55 and 74 kw
|
|
1 – connecting колодка;
2 – the gauge of temperature of a cooling liquid |
The gauge of temperature of a cooling liquid of the engine of 1,0 l, 37 kw and 1,4 l, 50 kw
|
|
1 – connecting колодка;
2 – the gauge of temperature of a cooling liquid |
The gauge of temperature of a cooling liquid of the engine of 1,9 l, 74 kw
|
|
1 – connecting колодка;
2 – the gauge of temperature of a cooling liquid |
The schedule of dependence of resistance of the gauge of temperature of a cooling liquid from gauge temperature
| PERFORMANCE ORDER |
| 1. Disconnect a wire from the plug - the storage battery. |
| 2. Merge cooling liquid (subsection 5.13 see). |
| 3. Remove the top casing of the engine (subsection 2.1 see). |
| 4. Disconnect колодку 1 (sm fig. the Gauge of temperature of a cooling liquid of the engine of 1,4 l, 55 and 74 kw, fig. the Gauge of temperature of a cooling liquid of the engine of 1,0 l, 37 kw and 1,4 l, 50 kw and fig. the Gauge of temperature of a cooling liquid of the engine of 1,9 l, 74 kw) with wires from the gauge of 2 temperatures of a cooling liquid. |
| 5. Remove the gauge and, having connected to its contacts an ohmmeter, measure resistance of the gauge. |
| 6. Heat up the gauge, having lowered it in hot water (temperature approximately 80 ), and again measure its resistance. Compare the received results to the schedule (fig. the Schedule of dependence of resistance of the gauge of temperature of a cooling liquid from gauge temperature see). For example, at temperature 30 About resistance of the gauge should make 1,5–2,0 clod, and at 80 With – 275–375 Ohm. If the measured resistance does not correspond specified, replace the gauge. |
|
|
|